A

B

C

D

Cut pipe square with pipe cutters. Chamfer the pipe with the beveler tool (code 05160). Apply neutral lubricant on the pipe.

Slacken the ring nut without removing from the body. Check that O-ring and clip are in proper position.

Insert the pipe end without tightening the ring nut. Push the fitting until the pipe oversteps the O-ring and reaches the stop.

Hand tighten the ring nut then tighten further with a strap/chain wrench.

A

B

C

D

Cut pipe square with pipe cutters. After preparing pipe ends, unscrew the fitting. Then, remove all internal components: the ring nut, the clip ring, the packing presser bush and the O-ring.

Push the pipe into the fittings until it reaches the stop. Insert the O-ring and position the same by inserting the packing-presser bush.

Displace the clip ring onto the pipe as shown in picture C.

Slide the ring nut over the clip ring and tighten with a strap/chain wrench in order to complete the assembly.